Message ID Description Recovery Action
21513-008009
[Warning] was displayed in
the storage system icon.
Clicking [Warning]
displayed "21513-008009"
in the Status field.
The user name and the password set in
Add System window might be incorrect.
Set the user name and the password in
the Storage Device List again.
21513-008011
[Warning] was displayed in
the storage system icon.
Clicking [Warning]
displayed "21513-008011"
in the Status field.
The information update failed.
This information updates automatically.
However, if the message does not
disappear after approximately five
minutes, select the corresponding
storage system from the Storage
Device List, stop the system, and then
restart it.
If the failure does not recover, restart the
SVP.
21513-008012
[Warning] was displayed in
the storage system icon.
Clicking [Warning]
displayed "21513-008012"
in the Status field.
Another SVP might be connected to the
storage system to be used.
Check whether services are running for
another storage system. If another SVP
already started the services of the
storage system, stop the services.
21542-005011 Clicking Apply in the Add
System window caused a
"(21542-005011) error"
and the storage icon is not
created.
The SVP does not have sufficient free
space to create the storage icon. Make
20 GB or more of free space available in
the installation directory of the drive.
21542-005019 Clicking Start Service
caused the error, and the
service cannot start.
Two or more services cannot run
simultaneously. Stop the service before
starting another service.
21542-005026 Clicking Start Service
caused the error, and the
service cannot start.
The SVP IP address is invalid. At the top-
right of the screen of the Storage
Device List window, click SVP IP
Address. In the Change SVP IP
Address window, set the IP address of
the SVP, and then retry Start Service.
The status of the service
changed to Error after
rebooting the SVP with the
Start-up service set to
Auto. The Service Status
window shows the error,
and the Status field shows
BASE.
The SVP IP address is invalid. At the top-
right of the screen of the Storage
Device List window, click SVP IP
Address. In the Change SVP IP
Address window, set the IP address of
the SVP, and then retry Start Service.
21542-005026
After starting Device
Manager - Storage
Navigator, a window is
displayed indicating you
cannot log in to Device
Manager - Storage
Navigator.
Two or more SVPs can be connected.
Only one storage system can connect to
an SVP at a time. If other SVPs are
connected, disconnect them and then,
restart the SVP you are using. If the SVP
is not connected, reboot the GUM from
the maintenance utility, and then restart
the SVP.
Troubleshooting the storage system 333
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
