Troubleshooting code Failure level Recovery action
TRNASB000003 ERROR
NAS Unified Firmware
Configuration Backup task
cannot be enabled.
Enable the NAS unified
firmware configuration backup
task.
TRNASB000004 ERROR
NAS Unified Firmware
Configuration Backup
notification cannot be
registered.
Contact customer support.
TRNASB000005 ERROR
NAS Unified Firmware
Configuration Backup
notification cannot be deleted.
Delete the NAS unified firmware
configuration backup
notification task.
TRNASB000006 ERROR
NAS Unified Firmware
Configuration Backup cannot be
performed due to an internal
error.
If this problem persists, contact
customer support.
TRNASB000007 WARN
The saving destination of NAS
Unified Firmware Configuration
Backup is not valid. Perform the
following procedure to check
the saving destination.
1. Click Control Panel >
Administrative Tools >
Task Scheduler to start.
2. Click Actions and confirm
that the description in the
Add arguments (optional)
is in the format specified
in the NAS unified
firmware configuration
backup.
TRNASB000008 WARN
The number of generations for
NAS Unified Firmware
Configuration Backup is not
valid. Perform the following
procedure to check the number
of generations.
1. Click Control Panel >
Administrative Tools >
Task Scheduler to start.
2. Click Actions and confirm
that the description in the
Add arguments (optional)
Troubleshooting the storage system 349
Service Guide for VSP Gx00 and VSP Fx00 Models
To Next Page
Loading...
