EQUIP
®
Series ACUIX™ IP PTZ Dome Installation and Configuration Guide
Document 800-04194V1 Rev A 95
07/11
Note When Quality is selected, the Target Bit Rate box is unavailable.
When Bit Rate is selected, the Compression Ratio box is
unavailable.
To set the priority:
1. Click the Compression Settings tab.
2. In the Compression Settings panel, in the Priority box, select Quality or
Bit Rate.
3. Click Apply.
Setting the Compression Ratio
The compression ratio is the ratio between the compressed data rate and the
uncompressed data rate. The higher the compression ratio, the greater the
bandwidth and disk space savings.
To set the compression ratio:
1. Click the Compression Settings tab.
2. In the Compression Settings panel, in the Compression Ratio box, select
one of the following:
• Minimum
•Low
•Medium
•High
•Maximum
3. Click Apply.
Setting the Target Bit Rate
You can set the amount of data (measured in kilobits) that is processed per
second.
To set the target bit rate:
1. Click the Compression Settings tab.
2. In the Compression Settings panel, in the Priority box, select Bit Rate.
3. In the Target Bit Rate (kbps) box, type a value from 400 to 5000.
4. Click Apply.
To Next Page
Loading...
