151430-L8 IDP and SD SLC Device Installation
7-2
7.2 List of SD SLC Devices
The following SLC devices can be used with the control panel. See the appropriate section number in this manual
or the device installation instructions (packaged with the device) for more information.
B210LP 6" mounting base I56-3739-00
B224BI/IV 6" isolator base. White or Ivory I56-0725-00
B224RB/IV 6" relay base. White or Ivory I56-3737-00
B501 4" mounting base I56-3738-00
B200SR-LF/IV
Low Frequency Sounder Base. White or Ivory
I56-4152-00
B200S-LF/IV
Low Frequency Sounder Base. White or Ivory
I56-4151-00
IDP-PHOTO-W/IV Photoelectric smoke detector. White or Ivory I56-6531-00
IDP-PHOTO-R-W/IV Photoelectric replacement smoke detector with remote test capability in DNR.
White or Ivory
I56-6532-00
IDP-PHOTO-T-W/IV Photoelectric smoke detector with thermal (135°F) White or Ivory I56-6534-00
IDP-HEAT-W/IV
Fixed temperature thermal detector (135°F). White or Ivory I56-6533-00
IDP-HEAT-ROR-W/IV Rate-of-rise thermal detector with 135° fixed temperature. White or Ivory I56-6533-00
IDP-HEAT-HT-W/IV
Fixed high temperature thermal detector (190°F). White or Ivory I56-6533-00
MODEL
NUMBER
MODEL NAME/DESCRIPTION
Installation
Sheet PN
SD505-PHOTO Photoelectric smoke detector
150955SD505-HEAT Absolute temperature heat detector.Trip point range from 135°F-150°F (0°-30°C)
SD505-6AB 6" base for use with the SD505-HEAT, SD505-AIS, and SD505-PHOTO.
SD505-6IB 6" short circuit isolator base for use with the SD505-HEAT, SD505-AIS, and SD505-
PHOTO.
151175
SD505-6RB 6" base for use with the SD505-HEAT, SD505-AIS, and SD505-PHOTO. 151192
SD505-6SB 6" base for use with the SD505-HEAT, SD505-AIS, and SD505-PHOTO.
151191
SD505-DUCT Duct Housing including the SD505-PHOTO Analog Photoelectric Smoke Sensor.
Intake tubing for duct available in three lengths: SD505-T2 (2.5 foot); SD505-T5 (5
foot); SD505-T10 (10 foot)
1700-098
SD505-DUCTR Duct housing with relay base including SD505-PHOTO Analog PhotoElectric Smoke
Sensor
SD500-PS/-
PSDA
Single or dual action addressable pull station
151177
SD500-AIM Addressable input module (switch input), standard size, DIP switch configurable 151071
SD500-MIM Mini input monitor module (switch input), small size, DIP switch configurable. Fits in
single-gang box with manual pull station switch.
151071
SD500-ANM Addressable notification module 151109
SD500-ARM Addressable relay module DIP switch configurable. 151091
SD500-SDM Addressable smoke detector module. Use to assign an address to a loop of
conventional devices.
151193
SD500-LIM Line isolator module. Fits in a double gang box. 151125
SD505-DTS-K Remote test switch & LED indicator for the SD505-DUCTR 1700-09882
Part Numbers Model Name/Description
Installation
Sheet PN