Honeywell Farenhyt IFP-2000 User Manual

Model IFP-2000/ECS Installation Manual 151430-L8
9-17
9.5.4 Point Programming for 5496
To program module points:
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 7 for Panel Programming.
3. Press 4 to enter point menu.
4. Press the Up or Down arrow to select the desired module. Refer to Section 8.6 for available choices, then
press ENTER.
Figure 9-7 Programming Points Screen for the 5880 Module
5. Enter the point number, then press ENTER.
6. Press the Up or Down arrow to select the type (See Figure 9-5 on page 19). Then press ENTER.
7. Press ENTER to edit point name. See Appendix B. Or Press the right arrow to skip point name edit.
8. Repeat Steps 1 through 7 for all points.
9.5.5 Point Programming for ECS-AMP’s
To program module points:
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 7 for Panel Programming.
3. Press 4 to enter point menu.
4. Press the Up or Down arrows to select the desired module. Refer to Section 8.6 for available choices. Then
press ENTER.
Figure 9-8 Programming Points Screen for the ECS-AMP Module
5. Enter the point number, then press ENTER. Points 5-8 on ECS-50W or ECS-125W will not be available
unless the ECS-CE4 is installed.
6. Press the Up or Down arrows to select the type (notification or unused), then press ENTER.
7. Press ENTER to edit point name. See Appendix B. Or Press the right arrow to skip point name edit.
Enter Point
Select AUX DOOR, CONSTANT
Select a name
for the Point
or AUX RESET
Enter Point
Select NOTIF or Unused
Select a name
for the Point

Honeywell Farenhyt IFP-2000 Specifications

General

Brand	Honeywell
Model	Farenhyt IFP-2000
Category	Conference System
Language	English