Contents
Section 1
Introduction ..................................................................................................................................................1
1.1 Overview of Basic System ...........................................................................................................1
1.1.1 Hardware Features ...............................................................................................................1
1.1.2 Network System Hardware Features ....................................................................................1
1.1.3 Software Features .................................................................................................................2
1.1.4 IFP-2000ECS Features ......................................................................................................... 2
1.2 About this Manual ........................................................................................................................2
1.2.1 Terms Used in this Manual ...................................................................................................3
1.3 Compatible Products ...................................................................................................................4
Section 2
Agency Listings, Approvals, and Requirements .......................................1
2.1 Federal Communications Commission (FCC) .............................................................................1
2.2 Underwriters Laboratories (UL) ...................................................................................................2
2.2.1 Requirements for All Installations .........................................................................................2
2.2.2 Requirements for Central Station Fire Alarm Systems .........................................................2
2.2.3 Requirements for Local Protected Fire Alarm Systems ........................................................2
2.2.4 Requirements for Remote Station Protected Fire Alarm Systems - (DACT) ........................3
Section 3
Before You Begin Installation ..............................................................................................1
3.1 What’s in the Box? ...................................................................................................................... 1
3.2 Environmental Specifications ......................................................................................................1
3.3 Electrical Specifications ...............................................................................................................1
3.4 Wiring Specifications ................................................................................................................... 4
3.5 Board Assembly Diagram ............................................................................................................7
3.6 Calculating Current Draw and Standby Battery ...........................................................................8
3.6.1 Current Draw Worksheet Requirements ...............................................................................8
3.6.2 Current Draw Worksheet for IDP SLC Devices ....................................................................8
3.6.3 Current Draw Worksheet for SD SLC Devices ...................................................................12
3.6.4 Maximum Battery Standby Load .........................................................................................16
3.7 Installation Task Overview ........................................................................................................16
Section 4
Control Panel Installation ..........................................................................................................1
4.1 Mounting the Control Panel Cabinet ........................................................................................... 1
4.1.1 Preventing Water Damage ....................................................................................................1
4.1.2 Removing the IFP-2000 Assembly from the Housing ...........................................................1
4.1.3 Ethernet Connection .............................................................................................................1