151430-L8 Programming
9-22
need to adjust it depending on the installation’s telephone system.
The selection made here must match the programming for this option in the Communication Configuration
dialog box of SKSS-2.
7. Enter the desired number of answer rings, then press ENTER.
9.6.2.3 Dial Option (TouchTone or Pulse, or TT/PL)
8. Press the Up or Down arrow to select the dial option, then press ENTER.
9.6.2.4 Rotary Format
9. Press the Up or Down arrow to select the pulse ratio for rotary dialing option, then press ENTER.
Options are:
9.6.2.5 Dial Tone Detection Disabled
10. Select Y (do disable) or N (don’t disable) by pressing the Up or Down arrow, then press ENTER.
9.6.2.6 Line Monitor
Enable the line monitor for each phone line that will be used. See Figure 9-10 for location of this field on the
phone lines screen. When the phone line monitor has been enabled for a phone line, a trouble condition will
occur if the line is not connected. If a phone line will not be used, it must be disabled.
11. Select Y (monitor line) or N (don’t monitor line) by pressing the Up or Down arrow, then press ENTER.
9.6.2.7 Answering Machine Bypass
This option is used in conjunction with SKSS-2. This feature ensures that an answering machine will not
interfere with communication between the panel and the computer. If an answering machine is used at the panel
site, enable this feature; if an answering machine is not used, disable the feature.
This option is factory-programmed as No (disabled).
The selection made here must match the programming for this option in the Communication Configuration
dialog box of SKSS-2. See the SKSS-2 manual for more information.
12. Select Y (answering machine bypass enabled) or N (answering machine bypass disabled) by pressing the Up
or Down arrow, then press ENTER.
9.6.2.8 Phone Line Unused
This option is used so that you can set unused phones lines to “Yes”, so no auto-test will be sent through that line.
This option is factory programmed as No.
13. Select Y or N by pressing the Up or Down arrow, then press ENTER.
Dial Option Description
PULSE If this option is selected, only pulse dialing will be used for this phone line.
TT TouchTone dialing. If this option is selected, only TouchTone dialing will be used for this
phone line.
TT/PL TouchTone alternating with pulse. If this option is selected, the dialer will first attempt to use
TouchTone. It will switch to pulse if TouchTone is not successful on the first attempt. It will
continue to alternate between TT and pulse for additional attempts.
U U.S. standard format. Uses the 60 msec / 40 msec make/break ratio.
E European format. Uses the 66 msec / 34 msec make/break ratio.
To Next Page
Loading...
Need help?
General
