EasyManuals Logo

Honeywell Farenhyt IFP-2000 User Manual

Honeywell Farenhyt IFP-2000
252 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #159 background imageLoading...
Page #159 background image
151430-L8 Programming
9-26
10. Then press the right arrow
or ENTER.
9.6.6.4 Both Ports Used
When the Both Ports Used option is set to Y (Yes), the IFP-RPT Repeater will supervise the network wiring on
both repeater ports.
11. Press the Up or Down arrow to toggle this selection between Y (Yes) or N (No).
12. Then press the right arrow or ENTER to make your selection and move to the next
programming option.
9.6.7 Daylight Saving Options
To edit Daylight Saving Time:
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 7 for Panel Programming.
3. Select 5 for System Options.
4. Select 6 for Daylight Saving Option.
9.6.7.1 Automatic Daylight Saving Adjustment
The control panel has an automatic DST (Daylight Saving Time) adjustment feature. Before January 2007, if this
feature is enabled (set to Yes), the system clock will switch to DST on the first Sunday in April at 2:00 a.m. and
revert to standard time on the last Sunday in October at 2:00 a.m. After January 2007, if this feature is enabled,
the system clock will start and end DST according to the settings of Daylight Saving Start and Daylight Saving
End (see Section Figure 9.6.7.2 on page 26). If this feature is not enabled (set to No), the Daylight Saving Time
change is not made to the system clock.
To enable or disable DST adjustment continue programming:
5. Select Y (enabled) or N (disabled) by pressing the Up or Down arrow, then press ENTER.
9.6.7.2 Daylight Saving Time Start and End
This option lets you to adjust the week and month Daylight Saving Time (DST) starts and ends. For this feature
to work, you must enable (set to Yes) the Automatic Daylight Savings Adjustment option under Daylight Savings
Options (see Section Figure 9.6.7.1 on page 26). The default values for the DST Start and End options reflect the
August 8, 2005 DST law that went into effect in 2007:
DST Start: The second Sunday in March
DST End: The first Sunday in November
To set the start and end for Daylight Saving Time:
6. Press the Up or Down arrow to select the week (1st, 2nd, etc.) Daylight Saving Time starts, then press
ENTER
to make your selection and move to the month setting.
7. Press the Up or Down arrow to select the month (January – December) Daylight Saving Time starts, then
press ENTER
to make your selection and move to the DST End option.
8. Press the Up or Down arrow to select the week (1st, 2nd, etc.) Daylight Saving Time ends, then press
ENTER
to make your selection and move to the month setting.
9. Press the Up or Down arrow to select the month (January – December) Daylight Saving Time ends, then
press ENTER
.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Honeywell Farenhyt IFP-2000 and is the answer not in the manual?

Honeywell Farenhyt IFP-2000 Specifications

General IconGeneral
BrandHoneywell
ModelFarenhyt IFP-2000
CategoryConference System
LanguageEnglish

Related product manuals