151430-L8 Programming
9-10
9.5 Point
You may need to change characteristics of individual input points (detectors and switches) even after using
JumpStart AutoProgramming. This section explains how to change options for: type of input point; latching/non-
latching status (switches); and name and zone/group assignment of a point.
9.5.1 Point Programming For 5815XL Module
To program for points on an 5815XL module, follow these steps:
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 7 for Panel Programming.
3. Press 4 to enter point menu.
4. Press the or arrows to select the desired module. Refer to Section 8.6 Quick Reference Table for
available choices.Then press ENTER.
5. Select S for sensor or M for module. (IDP Only)
6. Enter the number of the point you wish to edit, then press ENTER.
7. Select the type of device by pressing or arrows. Refer to Table 9-3 under the column heading “Type
Selection” for a list of choices.
To Next Page
Loading...
Need help?
General
