Honeywell Farenhyt IFP-2000 - System Options; Auto Test Time

151430-L8 Programming
9-20
9.6 System Options
This section of the manual explains how to customize software options that affect general operation of the
system. This includes such items as: AC loss reporting delay, system clock options, holiday schedule, telephone
and reporting account options. Refer to each individual subsection for complete instructions.
9.6.1 Auto Test Time
To access the Auto Test Time screen:
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 7 for Panel Programming.
3. Select 5 for System Options.
4. From the next menu, select 0 for Auto Test Time.
5. Enter the hour you desire the control panel to send an automatic test report (or press the Up or Down arrow),
then press ENTER.
6. Enter the minutes (or press the Up or Down arrow), then press ENTER.
7. Select AM or PM by pressing the Up or Down arrow, then press ENTER.
ECS-VCM/ECS-RVM
UNUSED
Refer to comments column of
Table 9-3 for description of these
options.
Latch or Non-latching feature only
appears for WATERFLOW, FIRE
SUPERVISORY, FIRE TAMPER, ZONE
AUX1, ZONE AUX2, SYSTEM AUX1,
SYSTEM AUX2, ECS INPUT, ECS
TAMPER, and ECS SUPERVISORY.
User also has ECS Event Number 1-8
option for ECS INPUT.
SWITCH
MANUAL PULL
WATERFLOW
FIRE SUPERVISORY
FIRE TAMPER
FIREDRILL
SILENCE
RESET
P.A.S. ACK
ZONE AUX1
ZONE AUX2
SYSTEM AUX1
SYSTEM AUX2
MANUAL RELEASE
INTERLOCK
STATUS POINT
ECS INPUT
ECS TAMPER
ECS SUPERVISORY
VOICE AUX STATUS 1-
2
VOICE AUX ECS 1-4
Table 9-5 Choices for Point Programming Modules
Choices Type Selections
Function Selections
for each Type
Comments