151430-L8 Control Panel Installation
4-14
4.6.1 5815XL Connection to the Panel
Connect the 5815XL to the control panel as shown in Figure 4-18. After the 5815XL is connected to the panel, it
must be added to the system. This programming steps are described in Section 9.2.2.
Figure 4-18 5815XL Connection to Main Panel Assembly
4.7 5824 Serial/Parallel Interface Module Installation
The 5824 serial/parallel interface module allows you to connect a printer to the panel, so you can print a real-time
log of system events. Instructions for installing the 5824 appear below. The 5824 is for ancillary use only.
5824 installation involves the following steps:
1. Make sure power is off at the panel.
2. Connect the 5824 to the panel as shown in Figure 4-19.
Note: Two 5824s per panel maximum.
3. Use the DIP switches on the 5824 board to assign an SBUS ID# to the 5824 (see Section 4.10.1).
4. Configure the 5824 device through programming. See Section 4.7.1.