151430-L8 Programming
9-28
4. Select 9 for Edit Ethernet.
Figure 9-15 Edit Ethernet Message
9.7 JumpStart AutoProgramming
To run JumpStart AutoProgramming:
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 7 for Panel Programming.
3. Select 6 for JumpStart AutoProgramming.
4. Press ENTER to accept the warning screen.
5. Follow the remaining on screen instructions.
6. Press ENTER to confirm. See Section 8.2.3.
9.8 Restore Defaults
This option allows you to restore the panel back to factory defaults. All programming will be lost.
1. Enter the installer code. The panel will automatically go to the main menu.
2. Select 7 for Panel Programming.
3. Select 7 for Restore Defaults.
4. Press the or arrow to select YES or NO from the warning screen. Then press ENTER.
9.9 Voice Options
Through this programming menu you can modify the messages programmed into an ECS-VCM. You can also
modify other voice settings.
9.9.1 ECS-VCM Maintenance
The ECS-VCM Maintenance menu is used to program custom messages into the ECS-VCM. Messages can be
recorded from audio coming from a computer or locally using the microphone.
IMPORTANT!
JumpStart AutoProgramming is used to auto learn the system hardware after devices have been added or removed from
the system. Hardware devices which remain the same between repeat JumpStarts will retain any customized text or
options associated with the device. It is best to carefully consider the network ID setting for each panel before the first
JumpStart is performed. Once this is done the panel must be defaulted back to factory defaults if the network ID settings
need to change.
To Next Page
Loading...
