151430-L8 System Operation
10-12
Alarm
A smoke
detector goes
into alarm or a
pull station is
activated.
The dialer seizes control of the phone line and
calls the central station.
The on-board annunciator will sound loud,
steady beeps to distinguish Alarm signals. For
Fire Alarm, the sequence is a loud steady
beep.(Any notification devices attached to the
system will also sound). For ECS Alarm, the
sequence is four seconds on, one second off.
GENERAL ALARM LED is on.
The LCD displays a screen similar to this one.
Press the down arrow to view the alarm. A screen
similar to this one displays.
Press SILENCE to silence the annunciator (and any
notification devices attached to the system).
When the alarm condition clears, press RESET to
restore the panel to normal.
Note: Alarm and Prealarm are combined into
single alarm count
Table 10-2: Operations Mode Behavior
Operation
Mode
Occurs When System Behavior In This Mode You Can
Count of alarms. In this example,
Press the down arrow to view the type
and location of alarm (Message
alternates with the date/time display).
are 5 in fire and 1 in ECS.
there
CO Detector
goes into Alarm
If more than 3
categories are
active at a single
time and ECS is
enabled, top
screen will
display, If ECS is
not enabled, it
will look like
bottom screen.
To Next Page
Loading...
