R400 Experion PKS Series A Fieldbus Interface Module User's Guide 117
July 2010 Honeywell
5. Configuration
5.1 Before You Start
What do you know about Control Builder?
If your answer to this question is nothing, please read at least the Starting Control
Builder section in the Control Building Guide in Knowledge Builder. This section shows
you how to launch the application.
You can skip this section, if you have used Control Builder before.
Do you know how to configure a Control Processor Module?
If y
our answer to this question is no, please read the Creating a CPM and CEE section
in the Control Building Guide in Knowledge Builder. This section shows you how to
create a Control Processor Module (CPM) and its associated Control Execution
Environment (CEE).
You can skip this section, if you have configured a CPM/CEE before.
Can you configure a Control Module?
If y
our answer to this question is no, please read at least the Creating and Saving a
Control Module section in Knowledge Builder. This section shows you how to create a
Control Module (CM) and insert and connect function blocks.
You can skip this section, if you have configured a CM before.
Are you familiar with your system architecture?
To c
omplete the configuration data for certain components, you must know the planned
or current location of the associated hardware components in your Experion system
architecture. This includes the chassis slot location for any given C200 CPM and CIOM-
A FIM. We suggest that you create a simple diagram that outlines the location of
components in your system showing slot locations and communication addresses for
reference during configuration.
Do you understand and have experience with fieldbus?
How successful you a
re at implementing a fieldbus system will depend largely on how
well you understand and/or are familiar with this relatively new technology. If you are
new to fieldbus, we suggest that you seek at least some overview level training before
trying to implement a fieldbus system.
To Next Page
Loading...
