11. Appendix B
11.1. Standard Function Block Parameters
R400 Experion PKS Series A Fieldbus Interface Module User's Guide 473
July 2010 Honeywell
2: Restart Resource
3: Restart with Defaults
4: Restart Processor
Usage
C/Contained
Length
1
Valid Views
Storage
Dynamic
Remarks
Changing this parameter, may be fatal to communication.
Note that the Restart with Defaults function restarts the
fieldbus device with factory default values instead of
Experion ones. To restore Experion default values, re-load
the device block through Control Builder with associated
blocks set for Full instead of Partial Load.
ROUT_IN
Classification
Record
Description
Represents target output and status provided by a host to a
control block for use as the block's output in ROUT mode.
FF Data Type
DS-65
Range
Usage
C/Remote-Output In
Length
5
Valid Views
VIEW_3
Storage
Dynamic
Remarks
The data type consists of the value and status of floating
point parameters that are Inputs or Outputs. It uses the
following two elements.
1 Status
2 Value
To Next Page
Loading...
