Honeywell Series A - 8.12 Using Fieldbus Methods Manager

8. Maintenance, Checkout, and Calibration
8.12. Using Fieldbus Methods Manager
R400 Experion PKS Series A Fieldbus Interface Module User's Guide 359
July 2010 Honeywell
Figure 35 Typical Other tab for fieldbus device's Transducer block.
8.12 Using Fieldbus Methods Manager
Prerequisites
Before you can launch Methods Manager you must:
Create the block type for a device from its manufacturer's DD files that include
methods data using the Type command in Control Builder.
Instantiate (create) and load the device block through Control Builder.