Honeywell Series A - Creating a Fieldbus device type from vendor DD

5. Configuration
5.4. Configuring Fieldbus Components In a Control Strategy
R400 Experion PKS Series A Fieldbus Interface Module User's Guide 141
July 2010 Honeywell
Step Action Result
13
Click the OK button.
This completes the configuration entries,
closes the form, and adds the data to the
database.
(Note that the system will generate an
error message detailing any problems with
the data entered and display it at this time,
so you can correct the errors before
closing the form.)
14
Repeat this procedure for Link 2 and use
LINK20105 as the link name.
Return to Step 1.
15
This completes the procedure. Go to the
next section Making a fieldbus device
Type from vendor DD.
Creating a Fieldbus device type from vendor DD
Use t
he following procedures to make a fieldbus device block type using the Type
function included with Control Builder and vendor supplied Device Description (DD)
files or Enhanced Device Description (EDD) files. This procedure assumes that Control
Builder is running and you have appropriate access level to create a control strategy.
TIP
You must have the Device Description (DD) files or Enhanced Device