Honeywell Series A - Page 319

8. Maintenance, Checkout, and Calibration
8.2. Unlike Device Replacement Report
R400 Experion PKS Series A Fieldbus Interface Module User's Guide 319
July 2010 Honeywell
General procedure for FF Unlike Device Replacement: This defines a high-level
procedure of unlike device replacement, which consists of some of the pre-
replacement and replacement steps.
Directly affected modules: This section lists all CMs and SCMs that contain
references to parent CMs of device function blocks, but do not directly contain
device functions blocks. These modules are listed because all parent CMs that are
deleted from the Monitoring side affect any CM or SCM that are connected."
The following are the information that are available on the directly affected modules.
ITEM COLUMN
CM Name “Affected Control Module”
CM Description (DESC
parameter)
“Description”
Assigned To “Reference end point
(Affected Module)”
Reference end point “Reference end point
(Affected Module)”
Reference source point “Reference source point
(To Be Deleted Module)”
Modules to be deleted: This section consists of a list of Control modules that must be
deleted during an Unlike Device Replacement because they contain function blocks
from the device to be replaced.
The following are the information that are available on the modules to be deleted.
ITEM COLUMN
CM Name “Container Module Name”
CM Description (DESC
parameter)
“Description”
Name of the device function
block
“Device Function Block”
The controller name in which
“Controller Name”