8. Maintenance, Checkout, and Calibration
8.3. Replacing Device Template with a Different One
326 Experion PKS Series A Fieldbus Interface Module User's Guide R400
Honeywell July 2010
Step Action
12
Confirm that the devices to be replaced are listed in the Summary list box.
13
Click the Replace Device button to initiate the replacement function.
14
Wait for the replacement process to be completed sequentially one device at
a time. Note any errors or warnings that may be displayed. Only devices with
no errors will be replaced.
(Click the Cancel button to exit the operation and start over after making any
necessary corrections.)
15
Check that the Status for each selected control turns to Replaced, when the
function is completed.
To Next Page
Loading...
