Honeywell Series A - Page 89

3. Fieldbus Integration With Experion System
3.8. Block Instantiation Support
R400 Experion PKS Series A Fieldbus Interface Module User's Guide 89
July 2010 Honeywell
If you want
to . . .
Then, Notes and References
Check
instantiated
block
configurati
on in
Project tab.
e) Right-click device block and
select Configure Module
Parameters from shortcut menu.
f) Click Block Instantiation tab.
g) Check Block Template Type
column for list of instantiated
blocks in device.
h) Check Block Tag column to view
assigned tag to see if block is
used in a Control Module or not
as shown in the following
illustration.
The Instantiation tab only
appears if the device
supports Block Instantiation.
See Checking device
configuration for reference