HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Guide

111
• trigger-only—NQA displays results on the terminal screen, and meanwhile triggers other
modules for collaboration.
The DNS operation does not support the action of sending trap messages.
Reaction entry
In a reaction entry, configure a monitored element, a threshold type, and an action to be triggered to
implement threshold monitoring.
The state of a reaction entry can be invalid, over-threshold, or below-threshold.
• Before an NQA operation starts, the reaction entry is in invalid state.
• If the threshold is violated, the state of the entry is set to over-threshold. Otherwise, the state of
the entry is set to below-threshold.
If the action is trap-only for a reaction entry, a trap message is sent to the NMS when the state of the
entry changes.
Configuration procedure
Before you configure threshold monitoring, configure the destination address of the trap messages
by using the snmp-agent target-host command. For more information about the command, see
Network Management and Monitoring Command Reference.
To configure threshold monitoring:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2.
Create an NQA
operation and
enter NQA
operation view.
nqa entry
admin-name operation-tag
By default, no NQA operations
exist.
3.
Enter NQA
operation view.
type
{
dhcp
|
dlsw
|
dns
|
ftp
|
http
|
icmp-echo
|
icmp-jitter
|
snmp
|
tcp
|
udp-echo
|
udp-jitter
|
udp-tracert
|
voice
}
The threshold monitoring feature
is not available for the path jitter
operation.
4. Enable sending
traps to the NMS
when specific
conditions are
met.
reaction trap
{
path-change
|
probe-failure
consecutive-probe-failures |
test-complete
|
test-failure
[ accumulate-probe-failures ] }
By default, no traps are sent to
the NMS.
The ICMP jitter, UDP jitter, and
voice operations support only
the
test-complete
keyword.
The following parameters are not
available for the UDP tracert
operation:
• The probe-failure
consecutive-probe-failures
option.
• The
accumulate-probe-failures
argument.
5. Configure
threshold
monitoring.
•
Monitor the operation duration (not
supported in the ICMP jitter, UDP jitter,
UDP tracert, or voice operations):
reaction item-number
checked-element probe-duration
threshold-type { accumulate
accumulate-occurrences | average |
consecutive consecutive-occurrences }
threshold-value upper-threshold
lower-threshold [ action-type { none |
trap-only } ]
N/A

HPE FlexNetwork 5510 HI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5510 HI Series
Category	Switch
Language	English