281
edit-config:
replace
Replaces the specified target.
•
exi
replaces the configuration
configuration carried in the
message.
• If the specified target does
not exist but is allowed to
target and then apply the
configuration of the target.
• If the specified target does
allowed to be created, the
operation is not conducted
and an invalid-value error
message is returned.
The syntax is the same as the edit-config message
with the merge
attribute. Change the operation
attribute from
merge
to
replace
.
edit-config:
remove
configuration.
• If the specified target has
only the table index, the
operation removes all
configuration
of the
specified target, and the
target itself.
• If the specified target has
the table index and
configuration data, the
operation removes the
specified configuration
data of this target.
• If the specified target does
message does not specify
message is returned.
The syntax is the same as the edit-config message
with the merge
attribute. Change the operation
attribute from
merge
to
remove
.
edit-config: delete
configuration.
• If the specified target has
only the table index, the
operation removes all
configuration
of the
specified target, and the
target itself.
• If the specified target has
the table index and
configuration data, the
operation removes the
specified configuration
data of this target.
• If the specified target does
message is returned,
does not exist.
The syntax is the same as the edit-config message
with the merge
attribute. Change the operation
attribute from
merge
to
delete
.
edit-config:
default-operation
Modifies the current
configuration of the device
using the default operation
To issue an empty operation for schema verification
purposes:
To Next Page
Loading...
Need help?
General