HPE FlexNetwork 5510 HI Series

89
To configure a router as a stub router:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter OSPF view.
ospf
[ process-id |
router-id
router-id |
vpn-instance
vpn-instance-name ] *
N/A
3. Configure the router as
a stub router.
stub-router
[
external-lsa
[ max-metric-value ] |
include-stub
|
on-startup
{ seconds |
wait-for-bgp
[ seconds ] } |
summary-lsa
[ max-metric-value ] ] *
By default, the router is not
configured as a stub router.
A stub router is not related to a
stub area.
Configuring OSPF authentication
Perform this task to configure OSPF area and interface authentication.
OSPF adds the configured key into sent packets, and uses the key to authenticate received packets.
Only packets that pass the authentication can be received. If a packet fails the authentication, the
OSPF neighbor relationship cannot be established.
If you configure OSPF authentication for both an area and an interface in that area, the interface
uses the OSPF authentication configured on it.
Configuring OSPF area authentication
You must configure the same authentication mode and key on all the routers in an area.
To configure OSPF area authentication:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter OSPF view.
ospf
[ process-id |
router-id
router-id |
vpn-instance
vpn-instance-name ] *
N/A
3. Enter area view.
area
area-id N/A
4. Configure area
authentication mode.
• Configure MD5 authentication:
authentication-mode { hmac-md5 |
md5 } key-id { cipher | plain } string
• Configure simple authentication:
authentication-mode simple
{ cipher | plain } string
• Configure keychain authentication:
authentication-mode keychain
keychain-name
By default, no
authentication is
configured.
For information about
keychains, see Security
Configuration Guide.
Configuring OSPF interface authentication
You must configure the same authentication mode and key on both the local interface and its peer
interface.
To configure OSPF interface authentication:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type interface-number N/A