HPE FlexNetwork 5510 HI Series

233
Step
Command
Remarks
instance-name ]
g. address-family ipv4
multicast
3. Specify the maximum
number of routes that a
router can receive from a
peer or peer group.
peer
{ group-name | ipv4-address
[ mask-length ] }
route-limit
prefix-number [ {
alert-only
|
discard
|
reconnect
reconnect-time } |
percentage-value ] *
By default, the number of routes
that a router can receive from a
peer or peer group is not limited.
To limit routes that a router can receive from a peer or peer group (IPv6 unicast/multicast address
family):
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP IPv6 unicast
address family view,
BGP-VPN IPv6 unicast
address family view, or BGP
IPv6 multicast address family
view.
• Enter BGP IPv6 unicast
address family view:
a. bgp as-number
[ instance
instance-name ]
b. address-family ipv6
[ unicast ]
• Enter BGP-VPN IPv6 unicast
address family view:
c. bgp as-number
[ instance
instance-name ]
d. ip vpn-instance
vpn-instance-name
e. address-family ipv6
[ unicast ]
• Enter BGP IPv6 multicast
address family view:
f. bgp as-number
[ instance
instance-name ]
g. address-family ipv6
multicast
N/A
3. Specify the maximum
number of routes that a
router can receive from a
peer or peer group.
peer
{ group-name | ipv6-address
[ prefix-length ] }
route-limit
prefix-number [ {
alert-only
|
discard
|
reconnect
reconnect-time } |
percentage-value ] *
By default, the number of routes
that a router can receive from a
peer or peer group is not limited.
Configuring BGP route filtering policies
Configuration prerequisites
Before you configure BGP routing filtering policies, configure the following filters used for route
filtering as needed:
• ACL (see ACL and QoS Configuration Guide).
• Prefix list (see "Configuring routing policies").