HPE FlexNetwork 5510 HI Series

466
Step
Command
Remarks
route-policy
route-policy-name } |
tag
tag ] *
to Level-2.
13. Specify the maximum
number of ECMP routes
for load balancing.
maximum load-balancing
number
By default, the maximum
number of ECMP routes equals
the maximum number of ECMP
routes supported by the system.
Configuring IPv6 IS-IS link cost
Configuring an IPv6 IS-IS cost for an interface
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter IS-IS view.
isis
[ process-id ] [
vpn-instance
vpn-instance-name ]
N/A
3. Specify an IS-IS cost
style.
cost-style
{
narrow
|
wide
|
wide-compatible
| {
compatible
|
narrow-compatible
} [
relax-spf-limit
] }
By default, the IS-IS cost
type is
narrow
.
4. Enter IPv6 address
family view.
address-family ipv6
[
unicast
] N/A
5. Enable IPv6 IS-IS MTR.
multi-topology
[
compatible
]
By default, IPv6 IS-IS MTR
is disabled.
6. Return to IS-IS view.
quit
N/A
7. Return to system view.
quit
N/A
8. Enter interface view.
interface
interface-type interface-number N/A
9. Enable IPv6 for IS-IS on
the interface.
isis ipv6 enable
[ process-id ]
By default, IPv6 is disabled
for IS-IS on an interface.
10. Specify an IPv6 cost for
the IS-IS interface.
isis ipv6 cost
cost-value [
level-1
|
level-2
]
By default, no IPv6 cost is
specified for the interface.
Configuring a global IPv6 IS-IS cost
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter IS-IS view.
isis
[ process-id ] [
vpn-instance
vpn-instance-name ]
N/A
3. Specify an IS-IS
cost style.
cost-style
{
wide
|
wide-compatible
|
compatible
}
By default, the IS-IS cost
style is
narrow
.
4. Enter IPv6 address
family view.
address-family ipv6
[
unicast
] N/A
5. Enable IPv6 IS-IS
MTR.
multi-topology
[
compatible
]
By default, IPv6 IS-IS MTR
is disabled.
6. Specify a global
IPv6 IS-IS cost.
circuit-cost
cost-value [
level-1
|
level-2
]
By default, no global IPv6
cost is specified.