499
interface-type
interface-number
[ backup-nexthop
ipv6-address ] |
backup-nexthop
ipv6-address }
Configuring the continue clause
Follow these guidelines when you configure the continue clause to combine multiple nodes:
• If you configure an apply clause that sets different attribute values on all the nodes, the apply
clause of the node configured most recently takes effect.
• If you configure the following apply clauses on all the nodes, the apply clause of each node
takes effect:
ï‚¡ apply as-path without the replace keyword.
 apply cost with the + or – keyword.
ï‚¡ apply community with the additive keyword.
ï‚¡ apply extcommunity with the additive keyword.
• The apply comm-list delete clause configured on the current node cannot delete the
community attributes set by the apply community clauses of the preceding nodes.
To configure the continue clause:
1. Enter system view.
system-view
N/A
2. Enter routing policy node
view.
route-policy
route-policy-name
{
deny
|
permit
}
node
node-number
N/A
3. Specify the next node to be
matched.
continue
[ node-number ]
By default, no continue clause is
configured.
The specified next node must
have a larger number than the
current node.
Displaying and maintaining the routing policy
Execute display commands in any view and reset commands in user view.
Display BGP AS path list information.
display ip as-path
[ as-path-number ]
Display BGP community list
information.
display ip community-list
[ basic-community-list-number |
adv-community-list-number |
name
comm-list-name ]
Display BGP extended community list
information.
display ip extcommunity-list
[ ext-comm-list-number ]
Display IPv4 prefix list statistics.
display ip prefix-list
[
name
prefix-list-name ]
Display IPv6 prefix list statistics.
display ipv6 prefix-list
[
name
prefix-list-name ]