428
3. Enable prefix
suppression for the
interface.
ospfv3 prefix-suppression
[
disable
]
[
instance
instance-id ]
By default, prefix suppression is
disabled for an interface.
Setting the maximum number of OSPFv3 logs
OSPFv3 logs include route calculation logs, neighbor logs, and LSA aging logs.
To set the maximum number of OSPFv3 logs:
1. Enter system view.
system-view
N/A
2. Enter OSPFv3 view.
ospfv3
[ process-id |
vpn-instance
vpn-instance-name ] *
N/A
3. Set the maximum number of
OSPFv3 logs.
event-log
{
lsa-flush
|
peer
|
spf
}
size
count
By default, the maximum number
of LSA aging logs, neighbor logs,
or route calculation logs is 10.
Configuring OSPFv3 authentication
OSPFv3 uses keychain authentication to prevent routing information from being leaked and routers
from being attacked.
OSPFv3 adds the Authentication Trailer option into outgoing packets, and uses the authentication
information in the option to authenticate incoming packets. Only packets that pass the authentication
can be received. If a packet fails the authentication, the OSPFv3 neighbor relationship cannot be
established.
The authentication mode specified for an OSPFv3 interface has a higher priority than the mode
specified for an OSPFv3 area.
Configuring OSPFv3 area authentication
1. Enter system view.
system-view
N/A
2. Enter OSPFv3 view.
ospfv3
[ process-id |
vpn-instance
vpn-instance-name ] *
N/A
3. Enter OSPFv3 area view.
area
area-id
N/A
4. Specify an authentication
mode for the area.
authentication-mode keychain
keychain-name
By default, no authentication is
performed for the area.
For more information about
keychains, see Security
Configuration Guide.
Configuring OSPFv3 interface authentication
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
To Next Page
Loading...
Need help?
General