329
[SwitchB] bgp 65009
[SwitchB-bgp-default] router-id 2.2.2.2
[SwitchB-bgp-default] peer 200.1.1.2 as-number 65008
# Configure the IBGP connection.
[SwitchB-bgp-default] peer 9.1.1.2 as-number 65009
# Enable GR capability for BGP.
[SwitchB-bgp-default] graceful-restart
# Inject networks 200.1.1.0/24 and 9.1.1.0/24 to the BGP routing table.
[SwitchB-bgp-default] address-family ipv4
[SwitchB-bgp-default-ipv4] network 200.1.1.0 24
[SwitchB-bgp-default-ipv4] network 9.1.1.0 24
# Enable Switch B to exchange IPv4 unicast routing information with Switch A and Switch C.
[SwitchB-bgp-default-ipv4] peer 200.1.1.2 enable
[SwitchB-bgp-default-ipv4] peer 9.1.1.2 enable
3. Configure Switch C:
# Configure IP addresses for interfaces. (Details not shown.)
# Configure the IBGP connection.
<SwitchC> system-view
[SwitchC] bgp 65009
[SwitchC-bgp-default] router-id 3.3.3.3
[SwitchC-bgp-default] peer 9.1.1.1 as-number 65009
# Enable GR capability for BGP.
[SwitchC-bgp-default] graceful-restart
# Enable Switch C to exchange IPv4 unicast routing information with Switch B.
[SwitchC-bgp-default-ipv4] peer 9.1.1.1 enable
Verifying the configuration
Ping Switch C on Switch A. Meanwhile, perform an active/standby switchover on Switch B. The ping
operation is successful during the whole switchover process. (Details not shown.)
BFD for BGP configuration example
Network requirements
As shown in Figure 75, configure OSPF as the IGP in AS 200.
• Establish two IBGP connections between Switch A and Switch C. When both paths operate
correctly, Switch C uses the path Switch A<—>Switch B<—>Switch C to exchange packets
with network 1.1.1.0/24.
• Configure BFD over the path. When the path fails, BFD can quickly detect the failure and notify
it to BGP. Then, the path Switch A<—>Switch D<—>Switch C takes effect immediately.
To Next Page
Loading...
Need help?
General