268
5. (Optional.) Enable load
balancing for routes that
have different AS_PATH
attributes of the same length.
balance as-path-relax
By default, BGP cannot perform
load balancing for routes that
have different AS_PATH
attributes of the same length.
To specify the maximum number of BGP ECMP routes for load balancing (IPv6 unicast/multicast
address family):
1. Enter system view.
system-view
N/A
2. Enter BGP IPv6 unicast
address family view,
BGP-VPN IPv6 unicast
address family view, or BGP
IPv6 multicast address family
view.
• Enter BGP IPv6 unicast
address family view:
a. bgp as-number
[ instance
instance-name ]
b. address-family ipv6
[ unicast ]
• Enter BGP-VPN IPv6 unicast
address family view:
c. bgp as-number
[ instance
instance-name ]
d. ip vpn-instance
vpn-instance-name
e. address-family ipv6
[ unicast ]
• Enter BGP IPv6 multicast
address family view:
f. bgp as-number
[ instance
instance-name ]
g. address-family ipv6
N/A
3. Specify the maximum
number of BGP ECMP
routes for load balancing.
balance
[
ebgp
|
eibgp
|
ibgp
]
number
By default, load balancing is
disabled.
4. (Optional.) Enable BGP to
ignore the AS_PATH
attribute when it implements
load balancing.
balance as-path-neglect
By default, BGP does not ignore
the AS_PATH attribute when it
implements load balancing.
5. (Optional.) Enable load
balancing for routes that
have different AS_PATH
attributes of the same length.
balance as-path-relax
By default, BGP cannot perform
load balancing for routes that
have different AS_PATH
attributes of the same length.
Configuring IPsec for IPv6 BGP
Perform this task to configure IPsec for IPv6 BGP. IPsec can provide privacy, integrity, and
authentication for IPv6 BGP packets exchanged between BGP peers.
When two IPv6 BGP peers are configured with IPsec (for example, Device A and Device B), Device
A encapsulates an IPv6 BGP packet with IPsec before sending it to Device B. If Device B
To Next Page
Loading...
Need help?
General