HPE FlexNetwork 5510 HI Series User Manual

271
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP instance view or
BGP-VPN instance view.
• Enter BGP instance view:
bgp as-number [ instance
instance-name ]
• Enter BGP-VPN instance
view:
a. bgp as-number [ instance
instance-name ]
b. ip vpn-instance
vpn-instance-name
N/A
3. Configure GTSM for the
specified BGP peer or peer
group.
peer
{ group-name | ipv6-address
[ prefix-length ] }
ttl-security hops
hop-count
By default, GTSM is disabled.
Configuring BGP soft-reset
After you modify the route selection policy, for example, modify the preferred value, you must reset
BGP sessions to apply the new policy. The reset operation tears down and re-establishes BGP
sessions.
To avoid tearing down BGP sessions, you can use one of the following soft-reset methods to apply
the new policy:
• Enabling route-refresh—The BGP router advertises a route-refresh message to the specified
peer, and the peer resends its routing information to the router. After receiving the routing
information, the router filters the routing information by using the new policy.
This method requires that both the local router and the peer support route refresh.
• Saving updates—Use the peer keep-all-routes command to save all route updates from the
specified peer. After modifying the route selection policy, filter routing information by using the
new policy.
This method does not require that the local router and the peer support route refresh but it uses
more memory resources to save routes.
• Manual soft-reset—Use the refresh bgp command to enable BGP to send local routing
information or advertise a route-refresh message to the specified peer. The peer then resends
its routing information. After receiving the routing information, the router filters the routing
information by using the new policy.
This method requires that both the local router and the peer support route refresh.
Enabling route-refresh
To enable BGP route refresh for a peer or peer group (IPv4 unicast/multicast address family):
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP instance view or
BGP-VPN instance view.
• Enter BGP instance view:
bgp as-number [ instance
instance-name ]
• Enter BGP-VPN instance
view:
a. bgp as-number
[ instance
instance-name ]
b. ip vpn-instance
N/A

HPE FlexNetwork 5510 HI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5510 HI Series
Category	Switch
Language	English