EasyManuals Logo

HPE FlexNetwork 5510 HI Series User Manual

HPE FlexNetwork 5510 HI Series
572 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #308 background imageLoading...
Page #308 background image
296
Step
Command
Remarks
3. Specify an AS number for
an LS peer or peer group.
peer
{ ipv4-address [ mask-length ] |
ipv6-address [ prefix-length ] }
as-number
as-number
peer
group-name
as-number
as-number
By default, no AS number is
specified.
4. Create the BGP LS
address family and enter its
view.
address-family link-state
N/A
5. Enable the device to
exchange LS information
with the peer or peer group.
peer
{ group-name | ipv4-address
[ mask-length ] | ipv6-address
[ prefix-length ] }
enable
By default, the device cannot
exchange LS information with
the peer or peer group.
Configuring BGP LS route reflection
Perform this task to configure a BGP route reflector and its clients. The route reflector and its clients
automatically form a cluster identified by the router ID of the route reflector. The route reflector
forwards route updates among its clients.
To configure BGP LS route reflection:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP instance view.
bgp
as-number [
instance
instance-name ]
N/A
3. Enter BGP LS address
family view.
address-family link-state
N/A
4. Configure the device as a
route reflector and specify
a peer or peer group as its
client.
peer
{ group-name | ipv4-address
[ mask-length ] | ipv6-address
[ prefix-length ] }
reflect-client
By default, no route reflector or
client is configured.
5. Enable route reflection
between clients.
reflect between-clients
By default, route reflection
between clients is enabled.
6. (Optional.) Configure the
cluster ID of the route
reflector.
reflector cluster-id
{ cluster-id |
ipv4-address }
By default, a route reflector uses
its own router ID as the cluster ID.
Specifying an AS number and a router ID for BGP LS
messages
Perform this task to ensure that LS messages sent by devices in the same AS have the same AS
number and router ID.
To specify an AS number and a router ID for BGP LS messages:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP instance view.
bgp
as-number [
instance
instance-name ]
N/A

Table of Contents

Other manuals for HPE FlexNetwork 5510 HI Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HPE FlexNetwork 5510 HI Series and is the answer not in the manual?

HPE FlexNetwork 5510 HI Series Specifications

General IconGeneral
BrandHPE
ModelFlexNetwork 5510 HI Series
CategorySwitch
LanguageEnglish

Related product manuals