HPE FlexNetwork 5510 HI Series User Manual

79
Step
Command
Remarks
set its router priority.
priority ]
The priority configured with this
command indicates whether a
neighbor has the election right or not.
If you configure the router priority for a
neighbor as 0, the local router
determines the neighbor has no
election right, and does not send hello
packets to this neighbor. However, if
the local router is the DR or BDR, it
still sends hello packets to the
neighbor for neighbor relationship
establishment.
Configuring the P2MP network type for an interface
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Configure the OSPF
network type for the
interface as P2MP.
ospf network-type p2mp
[
unicast
]
By default, the network type of an
interface depends on the link layer
protocol.
After you configure the OSPF
network type for an interface as
P2MP unicast, all packets are
unicast over the interface. The
interface cannot broadcast hello
packets to discover neighbors, so
you must manually specify the
neighbors.
4. Return to system view.
quit
N/A
5. Enter OSPF view.
ospf
[ process-id |
router-id
router-id |
vpn-instance
vpn-instance-name ] *
N/A
6. (Optional.) Specify a
neighbor and set its router
priority.
peer
ip-address [
cost
cost-value ]
By default, no neighbor is specified.
This step must be performed if the
network type is P2MP unicast, and
is optional if the network type is
P2MP.
Configuring the P2P network type for an interface
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter interface view.
interface
interface-type
interface-number
N/A
3. Configure the OSPF
network type for the
interface as P2P.
ospf network-type p2p
[
peer-address-check
]
By default, the network type of an
interface depends on the link layer
protocol.

HPE FlexNetwork 5510 HI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5510 HI Series
Category	Switch
Language	English