EasyManuals Logo

HPE FlexNetwork 5510 HI Series User Manual

HPE FlexNetwork 5510 HI Series
572 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #509 background imageLoading...
Page #509 background image
497
Step
Command
specified output interface.
interface-number }&<1-16>
configured.
This command is not
supported by BGP.
9. Match BGP routes having the
specified local preference.
if-match local-preference
preference
By default, no local
preference is configured for
BGP routes.
10. Match MAC addresses in EVI
IS-IS packets.
if-match mac-list
mac-list-name
By default, no MAC list
match criterion is configured.
The MAC list match criterion
applies only to EVI IS-IS. For
information about EVI IS-IS,
see EVI Configuration Guide.
11. Match routes having MPLS
labels.
if-match mpls-label
By default, no MPLS label
match criterion is configured.
12. Match routes having the
specified route type.
if-match route-type
{
external-type1
|
external-type1or2
|
external-type2
|
internal
|
is-is-level-1
|
is-is-level-2
|
nssa-external-type1
|
nssa-external-type1or2
|
nssa-external-type2
} *
By default, no route type
match criterion is configured.
13. Match IGP routes having the
specified tag value.
if-match tag
tag-value
By default, no tag match
criterion is configured.
14. Match VLANs in EVI IS-IS
packets.
if-match vlan
vlan-list
By default, no VLAN match
criterion is configured.
The VLAN match criterion
applies only to EVI IS-IS. For
information about EVI IS-IS,
see EVI Configuration Guide.
Configuring apply clauses
Except for the apply commands used for setting the next hop for IPv4 and IPv6 routes, all apply
commands are the same for IPv4 and IPv6 routing.
To configure apply clauses:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter routing policy node
view.
route-policy
route-policy-name {
deny
|
permit
}
node
node-number
N/A
3. Set the AS_PATH attribute for
BGP routes.
apply as-path
as-number&<1-32> [
replace
]
By default, no AS_PATH attribute is
set for BGP routes.
4. Delete the specified
COMMUNITY attribute for
BGP routes.
apply comm-list
{ comm-list-number |
comm-list-name }
delete
By default, no COMMUNITY
attribute is deleted for BGP routes.
5. Set the specified
COMMUNITY attribute for
BGP routes.
apply community
{
none
|
additive
|
{ community-number&<1-32> |
aa:nn&<1-32> |
internet
|
By default, no community attribute is
set for BGP routes.

Table of Contents

Other manuals for HPE FlexNetwork 5510 HI Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HPE FlexNetwork 5510 HI Series and is the answer not in the manual?

HPE FlexNetwork 5510 HI Series Specifications

General IconGeneral
BrandHPE
ModelFlexNetwork 5510 HI Series
CategorySwitch
LanguageEnglish

Related product manuals