HPE FlexNetwork 5510 HI Series

295
Step
Command
Remarks
peer or peer group.
reconnect
reconnect-time } |
percentage-value ] *
group is not limited.
15. Specify a preferred value for
routes received from the 6PE
peer or peer group.
peer
{ group-name | ipv4-address
[ mask-length ] }
preferred-value
value
By default, the preferred value
is 0.
16. Configure the device as a
route reflector and the 6PE
peer or peer group as a
client.
peer
{ group-name | ipv4-address
[ mask-length ] }
reflect-client
By default, no route reflector or
client is configured.
17. Configure the SoO attribute
for a peer or peer group.
peer
{ group-name | ipv4-address
[ mask-length ] }
soo
site-of-origin
By default, no SoO attribute is
configured for a peer or peer
group.
18. Return to user view.
return
N/A
19. Display information about the
6PE peer or peer group.
display bgp
[
instance
instance-name ]
peer ipv6
[
unicast
]
[ ipv4-address mask-length |
{ ipv4-address |
group-name
group-name }
log-info
|
[ ipv4-address ]
verbose
]
Available in any view.
20. Display routing information
advertised to or received
from the 6PE peer or peer
group.
display bgp
[
instance
instance-name ]
routing-table ipv6
[
unicast
]
peer
ipv4-address
{
advertised-routes
|
received-routes
} [ ipv6-address
prefix-length |
statistics
]
Available in any view.
21. Soft-reset a BGP 6PE
connection.
refresh bgp
[
instance
instance-name ] ipv4-address
[ mask-length ] {
export
|
import
}
ipv6
[
unicast
]
Available in user view.
22. Reset a BGP 6PE
connection.
reset bgp
[
instance
instance-name ] ipv4-address
[ mask-length ]
ipv6
[
unicast
]
Available in user view.
Configuring BGP LS
The BGP Link State (LS) feature implements inter-domain and inter-AS advertisement of link state
database (LSDB) and TE database (TEDB) information.
The device sends the collected link state information to the controller, which implements end-to-end
traffic management and scheduling, and meets the requirements of intended applications.
Configuring basic BGP LS
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP instance view.
bgp
as-number [
instance
instance-name ]
N/A