HPE FlexNetwork 5510 HI Series

272
Step
Command
Remarks
vpn-instance-name
3. Enable BGP route refresh for
a peer or peer group.
• Enable BGP route refresh for
the specified peer or peer
group:
peer { group-name |
ipv4-address
[ mask-length ] }
capability-advertise
route-refresh
• Enable the BGP route
refresh, multi-protocol
extension, and 4-byte AS
number features for the
specified peer or peer group:
undo peer { group-name |
ipv4-address
[ mask-length ] }
capability-advertise
conventional
By default, the BGP route refresh,
multi-protocol extension, and
4-byte AS number features are
enabled.
To enable BGP route refresh for a peer or peer group (IPv6 unicast/multicast address family):
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP instance view or
BGP-VPN instance view.
• Enter BGP instance view:
bgp as-number [ instance
instance-name ]
• Enter BGP-VPN instance
view:
a. bgp as-number
[ instance
instance-name ]
b. ip vpn-instance
vpn-instance-name
N/A
3. Enable BGP route refresh for
a peer or peer group.
• Enable BGP route refresh for
the specified peer or peer
group:
peer { group-name |
ipv6-address
[ prefix-length ] }
capability-advertise
route-refresh
• Enable the BGP route
refresh, multi-protocol
extension, and 4-byte AS
number features for the
specified peer or peer group:
undo peer { group-name |
ipv6-address
[ prefix-length ] }
capability-advertise
conventional
By default, the BGP route refresh,
multi-protocol extension, and
4-byte AS number features are
enabled.
Saving updates
To save all route updates from the specified peer or peer group (IPv4 unicast/multicast address
family):