HPE FlexNetwork 5510 HI Series

250
Figure 62 NEXT_HOP attribute configuration
IMPORTANT:
If you have configured BGP load balancing, the router sets itself as the next hop for routes sent to an
IBGP peer or peer group regardless of whether the peer next-hop-local command is configured.
To configure the NEXT_HOP attribute (IPv4 unicast/multicast address family):
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP IPv4 unicast
address family view,
BGP-VPN IPv4 unicast
address family view, or BGP
IPv4 multicast address family
view.
• Enter BGP IPv4 unicast
address family view:
a. bgp as-number
[ instance
instance-name ]
b. address-family ipv4
[ unicast ]
• Enter BGP-VPN IPv4 unicast
address family view:
c. bgp as-number
[ instance
instance-name ]
d. ip vpn-instance
vpn-instance-name
e. address-family ipv4
[ unicast ]
• Enter BGP IPv4 multicast
address family view:
f. bgp as-number
[ instance
instance-name ]
g. address-family ipv4
multicast
N/A
3. Specify the router as the next
hop for routes sent to a peer
or peer group.
peer
{ group-name | ipv4-address
[ mask-length ] }
next-hop-local
By default, the router sets itself as
the next hop for routes sent to an
EBGP peer or peer group.
However, it does not set itself as
the next hop for routes sent to an
IBGP peer or peer group.
To configure the NEXT_HOP attribute (IPv6 unicast/multicast address family):
Step
Command
Remarks
1. Enter system view.
system-view
N/A
Router A
Router B
AS 100 AS 200
1.1.1.1/24
Router C
1.1.1.2/24
1.1.1.3/24