HPE FlexNetwork 5510 HI Series

386
Destination IP: 2::9
Session State: Up Interface: N/A
Hold Time: 2012ms
The output shows that the BFD session has been created.
# Display the IPv6 static routes on Switch A.
<SwitchA> display ipv6 routing-table protocol static
Summary Count : 1
Static Routing table Status : <Active>
Summary Count : 1
Destination: 120::/64 Protocol : Static
NextHop : 2::9 Preference: 60
Interface : Vlan10 Cost : 0
Static Routing table Status : <Inactive>
Summary Count : 0
The output shows that Switch A communicates Switch B through VLAN-interface 10. The link over
VLAN-interface 10 fails.
# Display IPv6 static routes on Switch A again.
<SwitchA> display ipv6 routing-table protocol static
Summary Count : 1
Static Routing table Status : <Active>
Summary Count : 1
Destination: 120::/64 Protocol : Static
NextHop : 10::100 Preference: 65
Interface : Vlan11 Cost : 0
Static Routing table Status : <Inactive>
Summary Count : 0
The output shows that Switch A communicates with Switch B through VLAN-interface 11.