HPE FlexNetwork 5510 HI Series

73
Tasks at a glance
(Required.) Enabling OSPF
(Optional.) Configuring OSPF areas:
• Configuring a stub area
• Configuring an NSSA area
• Configuring a virtual link
(Optional.) Configuring OSPF network types:
• Configuring the broadcast network type for an interface
• Configuring the NBMA network type for an interface
• Configuring the P2MP network type for an interface
• Configuring the P2P network type for an interface
(Optional.) Configuring OSPF route control:
• Configuring OSPF route summarization
 Configuring route summarization on an ABR
 Configuring route summarization on an ASBR
• Configuring received OSPF route filtering
• Configuring Type-3 LSA filtering
• Setting an OSPF cost for an interface
• Setting the maximum number of ECMP routes
• Setting OSPF preference
• Configuring discard routes for summary networks
• Configuring OSPF route redistribution
 Redistributing routes from another routing protocol
 Redistributing a default route
 Configuring default parameters for redistributed routes
• Advertising a host route
• Excluding interfaces in an OSPF area from the base topology
(Optional.) Tuning and optimizing OSPF networks:
• Setting OSPF timers
• Setting LSA transmission delay
• Setting SPF calculation interval
• Setting the LSA arrival interval
• Setting the LSA generation interval
• Disabling interfaces from receiving and sending OSPF packets
• Configuring stub routers
• Configuring OSPF authentication
• Adding the interface MTU into DD packets
• Setting the DSCP value for outgoing OSPF packets
• Setting the maximum number of external LSAs in LSDB
• Setting OSPF exit overflow interval
• Enabling compatibility with RFC 1583
• Logging neighbor state changes
• Configuring OSPF network management
• Setting the LSU transmit rate
• Setting the maximum length of OSPF packets that can be sent by an interface
• Enabling OSPF ISPF
• Configuring prefix suppression
• Configuring prefix prioritization
• Configuring OSPF PIC