314
Predefined user roles
network-admin
Parameters
number: Specifies an action ID in the range of 0 to 231.
chassis chassis-number: Specifies an IRF member device by its member ID. If you do not specify a
member device, the command reboots all IRF member devices. (Distributed devices in IRF mode.)
slot slot-number: Specifies a card by its slot number. If you do not specify a card, this command
reboots all cards. (Distributed devices in standalone mode.)
slot slot-number: Specifies a card by its slot number. If you do not specify a card, this command
reboots all cards. (Distributed devices in IRF mode.)
slot slot-number: Specifies an IRF member device by its member ID. If you do not specify a member
device, the command reboots all IRF member devices. (Centralized devices in IRF mode.)
subslot subslot-number: Specifies a subcard by its slot number. If you do not specify a subcard, the
command reboots all subcards.
The following matrix shows the subslot subslot-number option and hardware compatibility:
Hardware Option compatibility
MSR954(JH296A/JH297A/JH298A/JH299A/JH373A) No
MSR958(JH300A/JH301A) No
MSR1002-4/1003-8S No
MSR2003 No
MSR2004-24/2004-48 No
MSR3012/3024/3044/3064 No
MSR4060/4080 Yes
Usage guidelines
You can configure a series of actions to be executed in response to the event specified in a monitor
policy. If two actions have the same ID, the most recent one takes effect.
EAA executes the actions in ascending order of action IDs. When you add actions to a policy, you
must make sure the execution order is correct.
The reboot action configured with this command reboots devices or cards without saving the running
configuration. If you want to save the running configuration, use the action cli command to configure
reboot actions.
When you define an action, you can specify a value or specify a variable name for an argument. For
more information about using EAA environment variables, see "rtm environment."
Examples
# (Distributed devices in standalone mode/centralized devices in standalone mode.) Configure an
action for the CLI-defined policy test to reboot the device.
To Next Page
Loading...
Need help?
General
