325
Table 63 Comparison operators
Comparison operator Description
eq
Equal to.
ge
Greater than or equal to.
gt
Greater than.
le
Less than or equal to.
lt
Less than.
ne
Not equal to.
Usage guidelines
Use interface event monitor policies to monitor traffic statistics on an interface.
You can configure only one event for a monitor policy. If the monitor policy already contains an event,
the new event replaces the old event.
EAA executes an interface event policy when the monitored interface traffic statistic crosses the start
threshold in the following situations:
• The statistic crosses the start threshold for the first time.
• The statistic crosses the start threshold each time after it crosses the restart threshold.
The following is the interface event monitor process of EAA:
1. Compares the traffic statistic sample with the start threshold at sampling intervals until the start
threshold is crossed.
2. Executes the policy.
3. Compares the traffic statistic sample with the restart threshold at sampling intervals until the
restart threshold is crossed.
4. Compares the traffic statistic sample with the start threshold at sampling intervals until the start
threshold is crossed.
5. Executes the policy again.
This process cycles for the monitor policy to be executed and re-executed.
Examples
# Configure a CLI-defined policy to monitor the incoming error packet statistic on GigabitEthernet
1/0/1 every 60 seconds. Set the start threshold to 1000 and the restart threshold to 50. Enable EAA
to execute the policy when the statistic exceeds 1000 for the first time. Enable EAA to re-execute the
policy if the statistic exceeds 1000 each time after the statistic has dropped below 50.
<Sysname> system-view
[Sysname] rtm cli-policy test
[Sysname-rtm-test] event interface gigabitethernet 1/0/1 monitor-obj input-errors
start-op gt start-val 1000 restart-op lt restart-val 50 interval 60
To Next Page
Loading...
Need help?
General
