huawei(config)#btv
huawei(config-btv)#igmp cascade-port 0/2/0
Configure the IGMP version.
huawei(config)#multicast-vlan 1000
huawei(config-mvlan1000)#igmp version v3
Configure the IGMP mode.
huawei(config-mvlan1000)#igmp mode proxy
Are you sure to change IGMP mode?(y/n)[n]:y
Configure a multicast uplink port.
huawei(config-mvlan1000)#igmp uplink-port 0/19/0
Configure multicast programs.
huawei(config-mvlan1000)#igmp program add batch ip 224.1.1.10 to-ip
224.1.1.100
sourceip 10.10.10.10
----End
11.4.1.6 Configuring the Service Flow on an ONU or HGW
This section describes how to configure the service flow on an optical network unit (ONU) or
a home gateway (HGW) to provide a user service.
Data Plan and Configuration Description
The data plan and configuration method for the Internet access service on an ONU or HGW in
Ethernet cascading scenarios are different from those in PON scenarios. The reason is as follows:
In Ethernet cascading scenarios, data is encapsulated in S-VLAN+C-VLAN mode on the ONU
and the OLT transparently transmits the S-VLAN tag (C-VLAN tag for the OLT) carried in
ONU packets. Each ONU uses an S-VLAN and it differentiates users by C-VLAN. In addition,
the user access modes are different. Specifically, in Ethernet cascading scenarios, users are
connected to the ONU through xDSL lines; in PON scenarios, users are connected to the ONU
through optical lines.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide 11 FTTB and FTTC Solution Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1036
To Next Page
Loading...
Need help?
General
