Huawei SmartAX MA5608T - Factory Defaults of the Xdsl Alarm Profile

Profile
Index
Profile Parameter Factory Default
G.SHDSL minimum line rate
(unit:kbps)
2048
G.SHDSL maximum line rate
(unit:kbps)
2048
PSD symmetric
Transmission mode all
Remote enable enabled
Probe enable disabled
Downstream current target SNR margin 6
Downstream worst target SNR margin 0
Upstream current target SNR margin 6
Upstream worst target SNR margin 0
Target SNR margin used bitmap 0x5
Reference times 0
1.6.3.2 Factory Defaults of the xDSL Alarm Profile
The following Table 1-53, Table 1-54, Table 1-55 list the factory defaults of the xDSL alarm
profile on the MA5600T/MA5603T/MA5608T.
Table 1-53 ADSL alarm profile
Profil
e
Index
Profile Parameter Factory
Default
1 DEFV
AL
CO The number of forward error correction
seconds
0
The number of errored seconds 0
The number of severely errored seconds 0
The number of loss of signal seconds 0
The number of unavailable seconds 0
CPE The number of forward error correction
seconds
0
The number of errored seconds 0
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide 1 Commissioning
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
207