16 OptiCable D-CMTS Configuration
(MA5633 Working as a Standalone NE)
About This Chapter
The 0ptiCable solution implements cable TV (CATV) and broadband signal transmission over
a coaxial network. It applies in CATV network reconstruction in upstream and downstream
directions or new residential areas requiring the CATV and broadband services over a coaxial
network. The radio frequency (RF) access mode applies in the PON+distributed cable modem
termination system (D-CMTS) scenario or GE+D-CMTS scenario. This mode complies with
the data over cable service interface specification (DOCSIS) and supports multiple broadcast
and TV services, such as high-speed Internet (HSI) and IPTV services.
16.1 D-CMTS Service Overview
This section describes the services supported by a distributed cable modem termination system
(D-CMTS) for multiservice operators (MSOs) from the aspect of basic concepts, networking
scenarios, and hardware configurations. This information provides a basis for configuring the
services on the D-CMTS.
16.2 Data Plan Principles for D-CMTS Services
This section describes the principles of planning frequency spectrum management, device
management, quality of service (QoS), and VLANs for distributed cable modem termination
system (D-CMTS) services.
16.3 Service Configuration on a D-CMTS That Works in GE Access Mode on a Layer 3 Network
This section describes how to configure services, including home services, L2VPN enterprise
service, and wireless local area network (WLAN) hotspot radio backhaul service, on a distributed
cable modem termination system (D-CMTS) that works in GE access mode on a Layer 3
network. The MA5603T equipped with the SCUV, OPGE, and SPUF boards is used as an
example.
16.4 Service Configuration on a D-CMTS That Works in GPON Access Mode on a Layer 3
Network
This section describes how to configure services, including home services, L2VPN enterprise
service, and wireless local area network (WLAN) hotspot radio backhaul service, on a distributed
cable modem termination system (D-CMTS) that works in GPON access mode on a Layer 3
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
16 OptiCable D-CMTS Configuration (MA5633 Working as
a Standalone NE)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1662
To Next Page
Loading...
Need help?
General
