EasyManuals Logo

Huawei SmartAX MA5608T User Manual

Huawei SmartAX MA5608T
1979 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1912 background imageLoading...
Page #1912 background image
When the IPv6 protocol is used, the QoS planning is the same for both IPv6 and IPv4.
l Management service: IPv4
l Voice service: IPv4
l IPTV service: N/A.
l Internet service: It is recommended that access devices use one flow to carry IPv6 and IPv4
Internet services. The QoS planning is the same for the flow that carries both IPv6 and IPv4
Internet services and the flow that carries only the IPv4 Internet service.
Internet Service Planning
The Internet service planning includes the VLAN and VLAN switching policy planning in
different networking scenarios.
IPv6 and IPv4 Internet services: It is recommended that devices use one flow to carry IPv6 and
IPv4 Internet services. This facilitates the control of the aggregate rate for IPv6 and IPv4 Internet
services. The QoS planning is the same for the flow that carries both IPv6 and IPv4 Internet
services and the flow that carries only the IPv4 Internet service. For details, see 11.2.3 Principle
of Internet Access Service Data Plan.
Voice Service Data Planning
Voice service data planning includes the VLAN/VLAN switching policy planning in different
networking scenarios, and voice protocol planning.
Even after IPv6 is used, the device still uses IPv4 to implement voice services.
19.3.3 Configuration Procedure
This section describes the IPv6 service configuration procedure by scenario, and compares it
with the IPv4 service configuration procedure.
FTTB (No HGW, LAN Access) Configuration Procedure
The following figure shows the IPv6 service configuration procedure in the FTTB (no HGW,
LAN access) scenario. In this scenario, the planning and configuration procedure/method for
IPv6 and IPv4 services are almost the same except the commands for configuring anti-IP
spoofing and DHCP option. For details, see 19.2 Configuration Difference Between IPv6 and
IPv4.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide 19 IPv6 Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1887

Table of Contents

Other manuals for Huawei SmartAX MA5608T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei SmartAX MA5608T and is the answer not in the manual?

Huawei SmartAX MA5608T Specifications

General IconGeneral
Dual Power SupplyYes
Humidity5% to 95% (non-condensing)
Uplink Slots2
Maximum GPON Ports16
Input Voltage Range-38.4 V DC to -72 V DC
Device TypeOLT
Power Supply-48 V DC
Operating Temperature-25°C to +55°C
Storage Temperature-40°C to 70°C
Switching Capacity128 Gbps
PortsGPON, XG-PON, 10GE

Related product manuals