Huawei SmartAX MA5608T User Manual

----End
1.6.2.4 Configuring the TFTP Transfer Mode
This topic describes how to configure the TFTP transfer mode for transferring (uploading or
downloading) files through the inband or outband Ethernet port of the MA5600T/MA5603T/
MA5608T. After the configuration, the TFTP server and the MA5600T/MA5603T/MA5608T
can communicate to transfer files in the TFTP mode.
Prerequisites
l The Ethernet port of the TFTP server is directly connected to the inband or outband Ethernet
port of the MA5600T/MA5603T/MA5608T.
– Connect to the inband Ethernet port (Maintenance port) through the crossover cable.
– Connect to the outband Ethernet port (Upstream port) through the direct cable.
l You have logged in to the MA5600T/MA5603T/MA5608T remotely from the console
(maintenance terminal), and have entered the global config mode.
Tools, Meters, and Materials
l Crossover cable
l Direct cable
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
1 Commissioning
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
199

Huawei SmartAX MA5608T Specifications

General

Dual Power Supply	Yes
Humidity	5% to 95% (non-condensing)
Uplink Slots	2
Maximum GPON Ports	16
Input Voltage Range	-38.4 V DC to -72 V DC
Device Type	OLT
Power Supply	-48 V DC
Operating Temperature	-25°C to +55°C
Storage Temperature	-40°C to 70°C
Switching Capacity	128 Gbps
Ports	GPON, XG-PON, 10GE