iid-map 2 pendingtime cs-mode client
huawei(config-sigtran)#iua-link add 15 1 1401 10.13.4.116 1400 10.14.1.2
jointly-work-with primary-mgc priority 3
Step 3 Configure the ISDN BRA user data.
huawei(config-sigtran)#quit
huawei(config)#esl user
huawei(config-esl-user)#mgbrauser add 0/3/1 0 1 interfaceid 10 terminalid 106
telno 88880000
Step 4 Save the data.
huawei(config-esl-user)#quit
huawei(config)#save
----End
Result
After the configuration is completed, two ISDN BRA users of the NT1 connected to port 0/3/1
can make calls successfully.
Configuration File
braport
braport attribute set 0/3/1 workmode p2mp autodeactive enable
quit
sigtran
iua-linkset add 1 mgid 0 jointly-work enable trafficmode override
iid-map 2 pendingtime cs-mode client
iua-link add 15 1 1401 10.13.4.116 1400 10.14.1.2
jointly-work-with primary-mgc priority 3
quit
esl user
mgbrauser add 0/3/1 0 1 interfaceid 10 terminalid 106 telno 88880000
quit
save
3.3.8 Example: Configuring the P2MP ISDN BRA Service(Based on
the SIP Protocol)
This topic describes how to configure the P2MP ISDN BRA service on the MA5600T/
MA5603T/MA5608T, which is applicable to the scenario where one NT1 is connected to
multiple terminals.
Service Requirements
l Two ISDN digital phones are connected to the MA5600T/MA5603T/MA5608T through
the same NT1.
l Basic rate interface (BRI) is adopted between the NT1 and the MA5600T/MA5603T/
MA5608T to provide a rate of 144 kbit/s, including two B channels and one D channel.
l Normal calls can be made on both phones.
Prerequisite
l The MA5600T/MA5603T/MA5608T must use the SIP protocol to communicate with the
IMS.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
3 Configuring the DSLAM Services
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
338
To Next Page
Loading...
Need help?
General
