Huawei SmartAX MA5608T User Manual

huawei(config-if-tdm-)#display port state 0
---------------------------------------
Port : 0
State : normal
Mode : UDT
Code : HDB3
Looptype : -
Timeslot : -
Clock : system
CRC4 : -
Signaling : -
ESF : -
Impedance : 120 Ohm
---------------------------------------
3. Query configurations and the status of the system clock source.
Run the display clock source command to query configurations and the status of the
system clock source.
huawei(config-if-tdm-)#quit
huawei(config)#display clock source
---------------------------------------------------------------
Index Config Type Source State Priority Output
---------------------------------------------------------------
0 YES line 0/0/1 Normal 0 YES
1 NO -- -/ -/ - --- --- ---
2 NO -- -/ -/ - --- --- ---
3 NO -- -/ -/ - --- --- ---
4 NO -- -/ -/ - --- --- ---
5 NO -- -/ -/ - --- --- ---
6 NO -- -/ -/ - --- --- ---
7 NO -- -/ -/ - --- --- ---
8 NO -- -/ -/ - --- --- ---
9 NO -- -/ -/ - --- --- ---
---------------------------------------------------------------
----End
14.4.1.7 Configuring Congestion Control and Security Policies
This topic describes how to configure global priority-based scheduling policies for queues to
ensure service reliability and configure global security policies to ensure service security.
Context
Congestion control uses queue scheduling technology to map packets sent from the same port
into multiple queues and process packets in each queue based on priority. Congestion control is
recommended.
Security policies cover system security, user security, and service security, which ensure normal
running of services.
NOTE
Enable security features based on service types. For details, see 13.2.5 Principle of Security Data Plan.
Procedure
l Configure queue scheduling.
Based on 13.2.3 Principle of QoS Data Plan, all packets use strict priorities for queue
scheduling and are mapped to queues based on priorities.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
14 FTTM Configuration (Base Station Access)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1408

Huawei SmartAX MA5608T Specifications

General

Dual Power Supply	Yes
Humidity	5% to 95% (non-condensing)
Uplink Slots	2
Maximum GPON Ports	16
Input Voltage Range	-38.4 V DC to -72 V DC
Device Type	OLT
Power Supply	-48 V DC
Operating Temperature	-25°C to +55°C
Storage Temperature	-40°C to 70°C
Switching Capacity	128 Gbps
Ports	GPON, XG-PON, 10GE