Name: Huawei SmartAX MA5608T
Brand: Huawei
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Figure 1-9 Configure the IP address and the subnet mask

NOTE

The IP address of the maintenance terminal and the IP address of the maintenance Ethernet

port of the device must be in the same network segment.

6. Click OK to return to the Local Area Connection Properties dialog box.

7. Click OK.

----End

Result

The IP address of the maintenance terminal and the IP address of the maintenance Ethernet port

of the device are in the same network segment.

NOTE

By default, the IP address of the maintenance network port (ETH port on the control board) is 10.11.104.2,

and the subnet mask is 255.255.255.0.

1.3.5 Logging In to the System

You must log in to the MA5600T/MA5603T/MA5608T before commissioning the MA5600T/

MA5603T/MA5608T through the maintenance terminal. The following describes three login

modes, namely, local serial port mode, telnet mode, and SSH mode. SSH with high priority is

recommended.

SmartAX MA5600T/MA5603T/MA5608T Multi-service

Access Module

Commissioning and Configuration Guide

1 Commissioning

Issue 01 (2014-04-30) Huawei Proprietary and Confidential

Other manuals for Huawei SmartAX MA5608T

Questions and Answers:

Need help?

Do you have a question about the Huawei SmartAX MA5608T and is the answer not in the manual?

General