EasyManuals Logo

Huawei SmartAX MA5608T User Manual

Huawei SmartAX MA5608T
1979 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1945 background imageLoading...
Page #1945 background image
Configure the voice
service
Start
Configure the L2 HIS
service
End
Configure the BTV
multicast service
Verifying services
Configure the VoD
service
Add an ONT to an OLT
Configure Link Aggregation, Congestion
Control, and Security Policy
NOTE
Texts in blue show the configuration difference between IPv6 and IPv4.
19.5.4 Configuration Example
Introduce the end-to-end service configuration based on the FTTH (Bridging ONT) networking
and the corresponding data plan.
Key Messages for Configuration
In this example, two ONTs are connected to the same PON port of the OLT. Triple play services
are required
l Even after IPv6 is used, the voice service is still realized by IPv4.
l Even after IPv6 is used, the OLT and ONT implement Layer 2 forwarding for HSI service
in this networking, irrespective of whether the access service is IPv4 or IPv6. Service
configurations for IPv4 and IPv6 are the same. For the HSI service from one end user, one
service flow is used to carry IPv6 and IPv4 Internet services, and the same service VLAN
is used.
l For multicast service, the OLT is the node to make multicast duplication. The configuration
procedure is the same for IPv4 multicast and IPv6 multicase. The IPv4 multicast service
and IPv6 multicast service can be configured in the same multicast VLAN on the OLT
equipment.
Data plan on the OLT side
The data of the bridging ONT can be configured through the web, the NMS, or the CLI at the
OLT side. In this example, the data of the ONT is configured through the CLI at the OLT side.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
19 IPv6 Configuration
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1920

Table of Contents

Other manuals for Huawei SmartAX MA5608T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei SmartAX MA5608T and is the answer not in the manual?

Huawei SmartAX MA5608T Specifications

General IconGeneral
Dual Power SupplyYes
Humidity5% to 95% (non-condensing)
Uplink Slots2
Maximum GPON Ports16
Input Voltage Range-38.4 V DC to -72 V DC
Device TypeOLT
Power Supply-48 V DC
Operating Temperature-25°C to +55°C
Storage Temperature-40°C to 70°C
Switching Capacity128 Gbps
PortsGPON, XG-PON, 10GE

Related product manuals