8. Check the ONU connection status.
In the navigation tree, choose Status > WAN Information. In the right pane,
Status is Connected and the obtained IP address is displayed at IP Address.
9. Check the registration status of the voice user.
In the navigation tree, choose Status > VoIP Information. In the right pane, User
Status is Up.
----End
12.4.2.8 Configuring the SIP-based Voice Service (Through the CLI)
The OLT manages ONUs and applies VoIP configurations to the ONU using the OMCI protocol.
This topic describes how to configure the SIP-based voice service.
Prerequisite
l The SIP interface data and POTS port data corresponding to the MG interface have been
configured on the SIP server.
l The connection between the OLT and the SIP server is set up. The OLT can ping the IP
address of the SIP server successfully.
SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
12 FTTO Configuration(SOHO and SME)
Issue 01 (2014-04-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1216
To Next Page
Loading...
Need help?
General
